Ambassador G’Kar Update 01

Ambassador G’Kar. Sculpted in Zbrush.


It’s  been a while while since I sculpted the G’akar model. As he’s one of my favourite Sci-Fi characters I wanted to make a fresh start on it again. Sculpting in Zbrush.


E.T. the Extra-Terrestrial 3D Print

E.T. 3D Print on an Ultimaker 2.

Finaly started to use the 3D printer again. So I tried an old model of mine from a while back. E.T the Extra-Terrestrial printed in Pla filament at around 7.5cm tall in low quality. Surprisingly the fingers came out at a couple of millimetres thick. No clean up just support material removed.